Specifications

TDB3104, WF3204 Installation
10 1/10/2013 Bradley • 215-1470 Rev. J; ECN 12-00-004
5a
Air Metering Valve Assembly for A Drain and O Drain Units
without Tie Pipe Option
A
Install hemmed end (not sharp end) of
support tube with gasket onto bowl.
B
Place sprayhead with 3/8" tubing onto
support tube. Run the tubing down through
the support tube and connect to valve tube
connector. Make sure the spray holes point
away from the wall.
C
Place the upper tie bar (notched at both
corners of each end) on top of sprayhead
parallel to wall. Connect the longer tie rod
to the 4-1/4" tie rod using the coupling nut
with hex head set screws. Run the tie rod
assembly down through upper tie bar and
secure from underneath the bowl using lower
tie bar (no notches) and hex nut with socket
head set screw.
Tie Rod Pre-Pack
Cover
Actuator
Module
Assembly
Coupling
Nut
Sprayhead
Tie Bar
Tie Rod
Supply Tube
Section View of
A/O Unit Assembly
Tie Rod Pre-Pack
(S45-1336)
Top Cover
(107-099 (A)
(107-179 (O)
Module
Cover
1/8" Air Tubes
Sprayhead
(S05-054B)
Drain
(S45-273)
Terreon
®
Semi-Circular Bowl
(Part No. Varies with color
of bowl. Contact your local
Bradley Rep for assistance)
Access Panel
(186-1456)
Valve Assembly
Standard Pedestal Assembly
(S17-259)
TAS Pedestal Assembly
(S17-345)
Tie Bar Pre-Pack
(S45-055)
1/2" Flexible
Supply Tube
Semi-Circ. Bowl Pre-Pack
(S45-1523)
Support
Tube Gasket
(125-011)
Support Tube
STD (S57-005)
TAS/JUV (S57-006)
Standard Tie Rod (176-008A)
Juvenile Tie Rod (176-008)
Tie Bar
Actuator Module
Assembly (S65-134)
Restraining Bracket
(140-126)
A/O
(A shown)