Specifications

Installation TDB3104, WF3204
Bradley • 215-1578 Rev. D; ECN 12-00-004 1/15/2013 9
4
Connect Supply Tubing to Sprayhead
A
Install 3/8" supply tubing in the sprayhead
using the male tube connector.
• Using a sharp razor, cut tubing squarely
and remove any burrs. DO NOT pinch or
crush end of tubing.
• Loosen nut on fitting. Moisten end of
tube and push into fitting until it is firmly
seated. Tighten nut to secure tube
to fitting (make sure nut is securely
tightened).
• If connector leaks, reseat tubing. If
leaking persists, replace male connector,
or call your Bradley representative for
assistance.
Sprayhead
Tubing
Male Tube
Connector
Nut
Tubing