Specifications

TDB3108, WF3208 Installation
8 1/23/2013 Bradley • 215-1471 Rev. F; ECN 13-00-001
CAUTION! Bowl surface is very smooth.
Approximate weight of bowl is
190 pounds. Handle with Care!
2
Bowl/Pedestal Mounting and Assembly
A
Position the pedestal making sure the
floor mounting holes (4) line up. Mark the
mounting-hole positions.
TAS OPTION: Place TAS spacer on floor
over the mounting holes. Place pedestal on
top of the spacer.
B
Secure pedestal to floor with suitable
fasteners, 1/2" anchors and bolts (supplied
by installer). Do not overtighten.
C
Using three or four people, carefully lift
bowl on to pedestal making sure drain
holes line up with floor drain and mate
thread rods with slotted holes in pedestal
using locator ribs.
D
Using 1/4" wing nuts and washers, secure
bowl to pedestal in four places.
Top View
Drain
Front View
Place Hands
Here When
Lifting Bowl
Place Hands
Here When
Lifting Bowl
Threaded Rod
(Secured by 1/4"
wing nut and
washer)
1/4" wing nuts
and washers
(4) Places
Locator Ribs
(4) Places
3
Installing Drain Spud in Bowl
A
Loosely attach the drain spud to the bowl
with the locknut and washer.
B TRAP OPTION: attach B trap to drain spud.
Tie Pipe OPTION: attach tie pipe bracket to
drain spud.
B
Tighten the spud and lock nut against the
bowl.
C
Secure the strainer to drain spud with the
screws provided.
D
Connect spud (or B Trap or Tie Pipe
Bracket) to drain.
Seal between drain spud and drain hole with
plumber’s putty (supplied by installer).
Strainer (S45-067)
Spud (112-015)
Bowl
Washer (142-068)
Locknut (161-021)
Drain Pre-Pack
(S45-273)
Floor Mounting
(4) Places
Threaded
Rods (4)
Places