Installation manual

Terreon® 54" Circular Deep Bowl Washfountain with Air Metering Valve
TDB3108, WF3208 Installation Instructions
Bradley Corporation • 215-1471 Rev. E; EN 06-915B12 4/6/2007
SUPPORT TUBE
GASKET
125-011
SUPPORT TUBE
(STD) S57-005
(JUV) S57-006
TIE ROD PRE-PACK
S45-1336
1/2" SUPPLY TUBE
PRE-PACK
S45-1466
PRE-PACK
S45-055
TIE BAR
PEDESTAL ASSY.
S17-242
COVER
107-099 (A)
107-179 (O)
ACTUATOR MODULE ASSY.
SPRAYHEAD
S05-054
TIE ROD
176-008A
DRAIN
S45-273
VALVE ASSY.
S08-373
ACCESS PANEL
186-1456
TERREON® DEEP BOWL
Part No. varies with color of bowl.
Contact your local Bradley Rep.
for assistance
NUT
MODULE COVER
S04-083
A/O
(A shown)
S65-132 (See Ilustration on page
18 for actuator components)
COVER
TIE ROD
PRE-PACK
TIE
ROD
COUPLING
NUT
SECTION VIEW OF
A/O UNIT ASSEMBLY
SPRAYHEAD
ACTUATOR
MODULE
ASSY.
TIE
BAR
SUPPLY TUBE
Figure 6
Installation Instructions continued . . .
Step 4a: Air Metering Valve assembly for A and O units without Tie Pipe option
1. Install hemmed end (not sharp end) of support tube with gasket onto bowl (see Figure 6).
2. Connect 1/2" supply tubing to sprayhead with 3/8" NPT to 1/2" tube connector and place spray-
head onto support tube. Run the tubing down through the support tube and connect to valve tube
connector.
3. Place the upper tie bar (notched at both corners of each end) on top of sprayhead. Connect the
longer tie rod to the 4-1/4" tie rod using the coupling nut with hex head set screws. Run the tie
rod assembly down through upper tie bar (see Figure 6 inset) and secure from underneath the
bowl using lower tie bar (no notches) and hex nut with socket head set screw.