Installation manual

DRAIN
TOP VIEW
FRONT VIEW
TDB 3108 BOWL - 190 LBS.
THREADED RODS
(4) PLACES
“A”
“A”
LOCATOR RIBS
(4) PLACES
1/4" WASHERS
AND WING NUTS
(4) PLACES
THREADED RODS
(4) PLACES
FLOOR MOUNTING
(4) PLACES
DRAIN
Terreon® 54" Circular Deep Bowl Washfountain with Air Metering Valve
TDB3108, WF3208 Installation Instructions
Bradley Corporation • 215-1471 Rev. E; EN 06-915B10 4/6/2007
Installation Instructions continued . . .
Step 2: Bowl/pedestal mounting and assembly (continued)
CAUTION: BOWL SURFACE IS SMOOTH. APPROXIMATE WEIGHT IS 190 LBS.
HANDLE WITH CARE!
1. Position the pedestal making sure the floor mounting holes (4) line up as shown in Figure 4a.
Mark the mounting-hole positions.
TAS Option:
Place TAS spacer on floor over the mounting holes. Place pedestal on top of the spacer.
2. Secure pedestal to floor with suitable fasteners, 1/2" anchors and bolts (supplied by installer). Do
not overtighten.
3. Using three or four people, carefully lift bowl at locations “A” (see Figure 4b) on to pedestal
making sure drain holes line up with floor drain and mate thread rods with slotted holes in
pedestal using locator ribs.
4. Using 1/4" wing nuts and washers, secure bowl to pedestal in four places.
Figure 4b
Figure 4a