Installation manual

Terreon® 54" Circular Deep Bowl Washfountain with with TouchTime
®
Control
Installation Instructions TDB3108, WF3208
Bradley Corporation • 215-1577 Rev A; EN 06-915B 134/6/2007
Installation Instructions continued . . .
4. Place the TouchTime module assembly on top of sprayhead. Rotate until actuator module locks
in with tie bar. Drop TouchTime module wires down to the valve assembly.
NOTE: Skip to number 5 for units without soap.
• For units with soap option, install the spacer, soap dispenser and cover using the third tie rod
(8-5/8" long) and second coupling nut as shown (see Figure 7). Secure with acorn nut and set
screw.
5. Secure TouchTime module cover and top cover with acorn nut and set screw.
6. FOR O UNIT: Install 1/2" nominal copper tubing supply lines (pass them through holes in
cover down through support column) and connect to stops using suitable fittings.
Figure 7
TOP COVER
SPRAYHEAD
S05-054
SUPPORT TUBE
(STD.) S57-005
(JUV.) S57-006
MODULE
COVER
COUPLING NUT
SPACER
TOUCHTIME
MODULE-
ASSEMBLY
S83-179
SOAP
DISPENSER
TIE ROD
21-5/8" (STD.)
18-1/8" (JUV.)
TIE BAR
UNIT WITH “O” DRAIN AND ACTUATOR MODULE
SHOWN, ALSO AVAILABLE WITH “A” DRAIN
COUPLING
NUT
8-5/8"
TIE ROD
4-1/4"
TIE ROD