Installation manual

Installation TDB3108, WF3208
Bradley • 215-1577 Rev. B; ECN 13-00-001 4/3/2013 9
E
Place the TouchTime module assembly on top of
sprayhead. Rotate until actuator module locks in
with tie bar. Drop TouchTime module wires down
to the valve assembly.
Skip to step G for units without soap.
F
For units with soap option, install the spacer, soap
dispenserandcoverusingthethirdtierod(8-5/8"
long)andsecondcouplingnutasshown.Secure
with acorn nut and set screw.
G
Secure TouchTime module cover and top cover
with acorn nut and set screw.
H
FOR O UNIT: Install1/2"nominalcoppertubing
supplylines(passthemthroughholesincover
downthroughsupportcolumn)andconnectto
stops using suitable fittings.
Unit with "O" Drain and
TouchTime Module Shown, Also
Available with "A" Drain
Top Cover
Soap Dispenser
8-5/8" Tie Rod
Spacer
Coupling Nut
Module
Cover
4-1/4" Tie Rod
TouchTime Module
Assembly
(S83-179)
Coupling Nut
Tie Bar
Sprayhead
(S05-054)
Standard Support Tube
(S57-005)
TAS/Juvenile Support Tube
(S57-006)
Standard Tie Rod
21-5/8"
Juvenile Tie Rod
18-1/8"
4a
Assemble TouchTime
®
– A and O Units without Tie Pipe Option (A Shown)