Installation manual

TDB3108, WF3208 Installation
6 4/3/2013 Bradley • 215-1577 Rev. B; ECN 13-00-001
Washfountain bowl and pedestal may be covered with
a protective coating that is very slippery. Thoroughly
clean and dry all lifting surfaces before assembling.
2
Bowl/Pedestal Mounting and Assembly
Threaded
Rods (4)
Places
Drain
Locator
Ribs (4)
Places
TDB 3108 Bowl - 190 lbs
(It's Very Heavy!)
1/4" Washers
and Wing Nuts
(4) Places
A
Position the pedestal making sure the floor mounting
holes(4places)lineupasshown.Markthemounting
hole positions on floor. Secure pedestal to floor with
suitable fasteners, 1/2"anchorsandbolts(suppliedby
installer).Donotovertighten.
C
Mate thread rods with slotted holes in pedestal
usinglocatorribs.Using1/4" wing nuts and
washers, secure bowl to pedestal in four places.
B
Usingthree or four people, carefully lift bowl
at locations shown onto pedestal, making
sure drain holes line up with floor drain.
Bowl surface is smooth and
possibly slippery.
Approximate weight is 190 lbs.
Handle with care!
TAS OPTION: Place TAS
spacer on floor over the
mounting holes. Place
pedestal on top of the spacer
before anchoring to floor.
Lift
Here
Lift
Here
Mixing Valve
Bracket
Front
Overhead View of Pedestal
(Bowl shown with dotted lines for reference)
Locator Ribs on
Bowl (4) Places
Threaded
Rod Holes
(4)
Floor
Mounting
Holes (4)
Drain