Installation manual

Installation TDB3108, WF3208
Bradley • 215-1577 Rev. B; ECN 13-00-001 4/3/2013 11
4b
Assemble TouchTime
®
– B and H Units without Tie Pipe Option (B Shown)
D
Place the TouchTime module assembly on top
of the sprayhead. Drop TouchTime module wires
down to the valve assembly.
Skip to step F for units without soap.
E
For units with soap option, slide the spacer and
soapdispenseroverthe1-1/2"pipe.
F
Position the upper tie bar slightly below the module
or soap dispenser and fasten securely to vent pipe
with set screws provided. Secure top cover to tie
bar with two cap screws provided.
G
FOR B UNIT:Install1/2"nominalcoppersupply
lines(passthroughholesincoverandthrough
supportcolumn)andconnectsupplylinestostops
using suitable fittings.
Top
Cover
Soap
Dispenser
Spacer
Module
Cover
TouchTime Module
Assembly (S83-179)
Tie Bar
Sprayhead
(S05-054)
Support Tube
Standard (S57-005)
TAS/Juv (S57-006)
Unit with "H" Drain and
TouchTime Module Shown, Also
Available with "B" Drain