Installation manual

13
Express® Lavatory System SS-Series
Installation Instructions SS-3N/IR/STD, SS-3N/IR/WH
Bradley Corporation • 215-1493 Rev. B; EN 03-808A 4/16/04
Soap Dispenser Maintenance
Step 1: Fill soap dispensers
The soap valves will dispense vegetable/coconut oil liquid soaps, synthetic detergents, viscous lotion
soaps, and antiseptic solutions. A 10-15% concentration is recommended for vegetable or coconut
oil liquid soaps. Synthetic detergents, lotion soaps, and antiseptic soaps require no dilution.
1. Using two screwdrivers (or similar tool), push up on the release tabs located beneath each soap
dispenser and pull out the soap tanks from the sprayhead (see Figure 8a).
2. To remove packing dust, rinse out each soap tank with hot water. Shake water out thoroughly
and allow to dry.
3. Pour the soap into each soap tank's filler hole (see Figure 8b).
4. After each soap tank is filled, position the soap tanks into the sprayhead openings and push into
place.
Figure 8a
Figure 8b
(3) ACTIVATION LABEL
204-476
(one above each activation
zone)
SOAP VALVE REPAIR KIT
S65-258 (qty. 2)
SOAP TANK
133-107 (GRAY)
133-131 (PUTTY)
133-131A (COAL)
(qty. 2)
FILLER HOLE