Installation manual

Express® Lavatory System SS-Series

Installation Instructions SS-2N/IR/STD, SS-2N/IR/WH

Bradley Corporation • 215-1497 Rev. B; EN 03-808A 4/16/04

Soap Dispenser Maintenance

Step 1: Fill soap dispenser

The soap valve will dispense vegetable/coconut oil liquid soaps, synthetic detergents, viscous lotion

soaps, and antiseptic solutions. A 10-15% concentration is recommended for vegetable or coconut oil

liquid soaps. Synthetic detergents, lotion soaps, and antiseptic soaps require no dilution.

1. Using two screwdrivers (or similar tool), push up on the release tabs located beneath the soap

dispenser and pull out the soap tank from the sprayhead (see Figure 8a).

2. To remove packing dust, rinse out the soap tank with hot water. Shake water out thoroughly and

allow to dry.

3. Pour the soap into the soap tank's filler hole (see Figure 8b).

4. After the soap tank is filled, position the soap tank into the sprayhead opening and push into

place.

Figure 8a

Figure 8b

ACTIVATION LABEL

204-476 (qty. 2)

(one above each

activation zone)

SOAP VALVE REPAIR KIT

S65-258

SOAP TANK

133-107 (GRAY)

133-131 (PUTTY)

133-131A (COAL)

FILLER HOLE