Specifications

Classic Circular 36"/54" Washfountain with Touch Time™ Control
Installation Instructions WF2605, WF2608 Terrazzo – WF2705, WF2708 Stainless Steel
13Bradley Corporation • 215-1518 Rev. C; EN 06-915B 4/6/2007
Installation Instructions continued . . .
Step 5b: Installing Supplies with Optional Soap Dispenser for B/H drain units
1. Install hemmed end (not sharp end) of support tube with gasket onto bowl as shown in Figure 9
on page 14.
2. Connect 1/2" supply tubing to sprayhead as shown in Figure 7 on page 11. Follow the
procedures below when installing 1/2" tubing into sprayhead to ensure that you achieve a
leakproof seal.
• Using a sharp knife, cut tubing squarely and remove any burrs. DO NOT pinch or crush end of
tubing.
• Loosen nut on fitting. Moisten end of tube and push into fitting until it is firmly seated. Tighten
nut to secure tube to fitting (make sure nut is securely tightened).
• If connector leaks, reseat tubing according to above procedure. If leaking persists, replace male
connector, or call your Bradley representative for assistance.
3. Place sprayhead with 1/2" tubing onto support tube as shown in Figure 9. Run tubing down
through support tube.
4. Connect the eight wires from the two Touch Time switches in the Touch Time module assembly
to the terminal block as shown in Figure 11 on Page 16.
5. Place Touch Time module assembly on top of sprayhead.
6. Drop the terminal block with wires attached down into the pedestal.
7. Insert the 1-1/2" vent pipe (supplied by installer, see page 4 for length) through the Touch Time
module, sprayhead, and support tube.
8. Connect to the vented trap provided.
9a. FOR UNITS WITH SOAP OPTION: Place the spacer, soap dispenser and cover in position on
top of Touch Time module (see Figure 9). Slide soap tie bar over 1-1/2" vent pipe 1/2" below top
of soap dispenser cover and secure with the two cap screws included with the tie bar. Slide the
dispenser cover over 1-1/2" vent pipe and secure with the two cap screws included with the tie bar.
9b. FOR UNITS WITHOUT SOAP OPTION: Slide module tie bar over 1-1/2" vent pipe, 1/2"
below top of Touch Time module and secure with set screws. Slide the dispenser cover over
1-1/2" vent pipe and secure with the two cap screws included with the tie bar.
10. Connect vent pipe to vent through ceiling with pipe union.
11. Continue installation with Step 6 on page 15.