Specifications

Classic Circular 36"/54" Washfountain with Infrared Control
Installation Instructions WF2605, WF2608 Terrazzo — WF2705, WF2708 Stainless Steel
11Bradley Corporation • 215-1449 Rev. D; EN 06-915B 4/6/2007
Installation Instructions continued . . .
Step 5a: Installing Supplies with Optional Soap Dispenser for A/O drain units
NOTE: See Step 5b on page 13 for Type B/H drain units.
NOTE: For models with optional paper towel dispensers, tie pipe assembly, or shroud, see separate
instruction sheets and Step 5b for units with type B/H drain.
1. Install hemmed end (not sharp end) of support tube with gasket onto bowl as shown in Figure 8
on page 12.
2. Connect 1/2" supply tubing to sprayhead as shown in Figure 7. Follow the procedures below
when installing 1/2" tubing into sprayhead to ensure that you achieve a leakproof seal.
• Using a sharp knife, cut tubing squarely and remove any burrs. DO NOT pinch or crush end
of tubing.
• Loosen nut on fitting. Moisten end of tube and push into fitting until it is firmly seated.
Tighten nut to secure tube to fitting (make sure nut is securely tightened).
• If connector leaks, reseat tubing according to above procedure. If leaking persists,
replace male connector, or call your Bradley representative for assistance.
3. Place sprayhead with 1/2" tubing onto support tube as shown in Figure 8 on page 12. Run tubing
down through support tube.
4. Assemble the lower tie rod (the longer threaded rod), upper tie bar (notched at corners), lower tie
bar, tie rod nut, and coupling nut, then attach the 4-1/4" tie rod to coupling nut as shown in
Figure 8.
5. Place infrared module assembly on top of sprayhead. Rotate until infrared module locks in with
tie bar. Drop the infrared module wires down into the pedestal.
6a. FOR UNITS WITH SOAP OPTION: Install the soap dispenser gasket, spacer, soap dispenser,
and dispensercover using the coupling nut, third tie rod (8-5/8" long) and second coupling nut as
shown (see Figure 8). Secure with acorn nut and socket head set screw.
6b. FOR UNITS WITHOUT SOAP OPTION: Secure infrared module cover and dispenser cover
with acorn nut and socket head set screw.
7. Continue installation with Step 6 on page 15.
NUT
TUBING
MALE
1/2" TUBE
CONNECTOR
269-626
SPRAYHEAD
Figure 7
TUBING