Specifications

Classic Circular 36"/54" Washfountain with Infrared Control
WF2605, WF2608 Terrazzo — WF2705, WF2708 Stainless Steel Installation Instructions
2 4/6/2007 Bradley Corporation • 215-1449 Rev. D; EN 06-915B
Pre-Installation Information
Infrared Control
Hands placed within the bowl are detected by an infrared sensor module which activates a solenoid
valve starting the flow of tempered water from the sprayhead. Shut-off is automatic seven seconds
after hands are removed from the detection area.
Supplies required for installation:
• (8) 1/2" lag bolts, screws or other fasteners to anchor washfountain pedestal to floor
• 1" hot and cold water supply lines and fittings (refer to rough-ins on pages 5-6)
• Reducing fittings and 1/2" nom. copper tubing supply lines for types with supplies from
above
• 2" drain lines and fittings (refer to rough-ins on pages 5-6)
• Standard P-trap (refer to rough-ins on page 7, special vented trap supplied for B and H type)
• Pipe sealant and plumber’s putty
• 1-1/2" vent pipe on types vented through washfountain column (refer to page 4 for lengths
required)
• 110 VAC GFI power source for 110/24 VAC UL Class II transformer supplied
• OPTIONAL: Bradley recommends installing an electrical cut-off switch to the unit. This
feature prevents accidental water delivery during regular maintenance and service.
NOTE: Supply lines for one or two washfountains should be 1"; for three washfountains 1-1/4"; for
more than three washfountains pipe size should increase proportionally. Vent pipe to be 1-1/2" on
models vented through washfountain.
Bradley Classic Washfountain Warranty Information
Product warranties may be found under “Product Information” on our website at www.bradleycorp.com