Specifications

Classic Circular 36"/54" Washfountain with Air Valve Control
Installation Instructions WF2605, WF2608 Terrazzo – WF2705, WF2708 Stainless Steel
15Bradley Corporation • 215-1521 Rev. D; EN 06-915B 4/6/2007
Installation Instructions continued . . .
Step 6: Valve connections for air valve
NOTE: Flush supply lines before making connections.
1. Connect the stop-strainer-check valves, mixing valve, volume control valve and air valve
assembly to the supplies. Use pipe sealant to seal threads.
3. For overhead supply lines, install 1/2" nominal copper supply tubing by passing the lines through
the holes in the dispenser cover and then down through the support tube.
3. Using suitable fittings, install the complete valve assembly to the supplies as shown in Figure 10
at the approximate height indicated in Table 2.
4. Connect the 1/2" supply tubing from the sprayhead to the male connector in the air valve assembly.
5. Connect the 1/8" tubing from the actuators to the tee, then connect 1/8" tubing from the tube
connector on the air valve to the tee (Figure 10).
NOTE: Insert the end of the tubing into the connector until it is firmly seated on the tube stop (See Figure 11).
Model Number Type A Type B Type O Type H
Standard Height 9" (229mm) 6-3/16" (157mm) 9" (229mm) 6-3/16" (157mm)
Juvenile Height 5-1/4" (133mm) 3-7/16" (87mm) 5-1/4" (133mm) 3-7/16" (87mm)
Table 2 — Distance from 1/2" Supply to Finished Floor
1/2" SUPPLY TUBING
FROM SPRAYHEAD
3/8 NPT x 1/2" O.D . TUBE CONNECTOR
(269-626)
3/8 NPT NIPPLE
(113-006AL)
REDUCER (169-059)
VOLUME CONTROL
VALVE (S02-045)
AIR VALVE
(S07-044)
CHECK VALVE
(269-1140)
ADAPTER
(198-008)
1/8" TUBE
CONNECTOR
(169-890)
1/8" O.D . TEE (S53-046)
1/8" O.D . TUBING
TO ACTUATORS
Distance
To Finished
Floor
(See Ta ble 2)
1/2" SUPPLY
1/2" SUPPLY
STOP-STRAINER-CHECK
VALVE (S60-003)
TMA (OPTIONAL)
(S01-525)
TAILPIECE (129-007)
MANUAL MIXING VALVE
(S01-038)
TAILPIECE NUT (110-005)
FIBER WASHER (124-001AF)
Figure 10