Installation Guide

ManualsBrandsBradley ManualsEmergency & Safety EquipmentBradley Wall Mounted Chrome Plated Brass Drench Shower with Horizontal Supply and Plastic Shower Head with Stainless Steel Shroud

1

2

3

3

Installation S19-120T

Bradley • 215-148CP Rev. N; ECN 17-05-039 7/18/2017

Supplies Required

• Pipe sealant and teflon tape

• Piping to 1" NPT water supply inlet

• Adequate supply pipe supports

• Minimum 4" (102 mm) drain to

accommodate 30 gallons (115 liters) per

minute discharge for shower waste

• Sign-mounting hardware

Assemble components

1. Assemble components as shown on page 4.

2. Apply pipe sealant or tape (by installer) to

all male-threaded pipe joints.

3. Bottom edge of showerhead should be

7'-0" (2134 mm) from the floor.

Connect water supply

NOTICE! Do not rely on Bradley’s Drench

Shower to support supply piping.

1. Connect water supply piping to 1" NPT

inlet on unit (piping supplied by installer).

Provide adequate supports (supplied

by installer) for supply pipe using pipe

hangers or other means.

2. Mount the safety sign to the wall using

sign-mounting hardware supplied by

installer.

5-1/4"

(133mm)

9"

(229mm)

Ø 10-3/4"

(273mm)

15-7/8"

(403mm)

7'-0"

(2134mm)

Suggested

Height to

Floor

24"

(610mm)

3-5/8"

(92mm)