Specification Sheet

S19-120, S19-120A, S19-120SS
Drench Shower with Horizontal Supply
© 2018 Bradley
P.O. Box 309, Menomonee Falls, WI 53052-0309
800 BRADLEY (800 272 3539) [phone]
bradleycorp.com
Page 2 of 3 10/22/2018
This information is subject to change without notice.
Bradley_DrenchShower_S19-120_A_SS
Valve
Chrome-plated brass 1" NPT stay-open ball valve, operated by stainless steel pull rod
with triangular handle. Model S19-120SS is all stainless steel.
Pipe and Fittings
1¼" galvanized steel with BradTect
®
safety yellow coating. S19-120SS is all stainless
steel.
Water Supply
1" NPT Horizontal (BSPP model only)
Local codes may require the installation of a backflow prevention valve to
complete proper installation. Compliance with local codes is the responsibility
of the installer. Valve must be tested annually to verify that it is functioning
properly. Backflow prevention valves are not included with the fixture and may
be supplied by the contractor or purchased from Bradley Corporation.
SpinTec Flow Rate vs Inlet Pressure at Fixture
0
5
10
15
20
25
30
35
40
10 20 30 40 50 60 70 80 90
Inlet pressure at Fixture (psig)
Flow Rate (gpm)
Standard Equipment
SpinTec™ Showerhead
Standard showerhead is 3.1" (78.7mm) diameter highly visible yellow impact-resistant
plastic (Model S19-120A includes a 10¾" [273mm] diameter corrosion-resistant
stainless steel shroud). High performance corrosion-resistant stainless steel
showerhead measures 1½" (38mm) in diameter (Model S19-120SS only). SpinTec
drench showerhead features integral 22 GPM (83.3 L) flow control, conserving water
and helping to accurately size your tepid water system.