Installation Guide

3
Installation S19-120SS
Bradley • 215-279 Rev. J; ECN 12-05-016A 5/25/2012
Installation
Supplies Required:
• Pipesealant
• Pipingto1"NPTwatersupplyinlet
• Adequatesupplypipesupports
• Minimum4"(102mm)draintoaccommodate30
gallons(115liters)perminutedischargeforshower
waste
• Sign-mountinghardware
Step 1: Assemble components
1. Assemblethecomponentsasshownonpage4.
• Applypipesealanttoallmale-threadedpipe
joints.
• Bottomedgeofshowerheadshouldbe84"
(2134 mm) from the floor.
Step 2: Connect water supply
IMPORTANT: Do not rely on Bradley’s
Drench Shower to support supply piping.
1. Connectwatersupplypipingto1"NPTinlet
on unit (piping supplied by installer). Provide
adequatesupports(suppliedbyinstaller)for
supply pipe using pipe hangers or other means.
2. Mountthesafetysigntothewallusingsign-
mountinghardwaresuppliedbyinstaller.
3
5
⁄8"
(92mm)
9"
(229mm)
3¾"
(95mm)
15¾"
(400mm)
84"
(2134mm)
to Floor
25½"
(648mm)
1½"
(38mm)