Installation Guide

ManualsBrandsBradley ManualsEmergency & Safety EquipmentBradley Flush Mounted Barrier Free Drench Shower with Horizontal Supply

Installation

P.O. Box 309

Menomonee Falls, WI 53052 USA

800 BRADLEY (800 272 3539)

+1 262 251 6000

bradleycorp.com

215-1261 Rev. G; ECN 17-05-039

Page 1 of 4 7/18/2017

S19-120FMBF

Barrier Free Flush-Mount Drench

Shower - Horizontal Supply

Table of Contents

Pre-Installation Information ............................................................ 2

Supplies Required ........................................................................... 3

Install drench shower ......................................................................3

Connect water supply ......................................................................3

Assembly of Components ...............................................................4

Parts List .........................................................................................4

Summary of content (4 pages)

PAGE 1
Installation S19-120FMBF Barrier Free Flush-Mount Drench Shower - Horizontal Supply Table of Contents Pre-Installation Information............................................................. 2 Supplies Required............................................................................3 Install drench shower.......................................................................3 Connect water supply.......................................................................3 Assembly of Components.............
PAGE 2
S19-120FMBF Installation WARNING Flush the water supply lines before beginning installation and after installation is complete. Test the unit for leaks and adequate water flow. Main water supply to the eyewash should be “ON” at all times. Provisions shall be made to prevent unauthorized shutoff. CAUTION Emergency equipment must be supplied with tepid water (60°F to 100°F/15.6°C to 37.8°C).
PAGE 3
S19-120FMBF Installation Supplies Required • Pipe sealant • Piping to 1" NPT water supply inlet Ø 5" (127mm) 2" (51mm) 2" (51mm) • Adequate supply pipe supports • Minimum 4" (102 mm) drain to accommodate 30 gallons (115 liters) per minute discharge for shower waste 1-7/8" (48mm) • (2) Ceiling fasteners (holes in cover plate are Ø 1/4") • Sign-mounting hardware Ø 3-1/4" (83mm) Ø 5/16" (8mm) (2) places 20-1/8" (511mm) Install drench shower 1. Rough-in the necessary ceiling cutouts as shown. 2.
PAGE 4
S19-120FMBF Installation Assembly of Components 1 1" NPT Supply Inlet 1.2 1.3 1.4 1.5 1.21 2 3 (2) ceiling fasteners (by installer) 6.1 5 6.2 6 6.4 Align handle pieces as shown. 4 6.5 NOTE: Use teflon tape only. 7 P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA TEL: 1-800-BRADLEY FAX: (262-251-5817) http://www.bradleycorp.com 114-051 NOTE: Items 1.1–1.5 come preassembled as Item 1. R P.O. Box 309, Menomonee Falls, WI 53051 TEST THIS UNIT EACH WEEK DIESES GERÄT 1ST WÖCHENTLICH ZU PRÜFEN.