Installation Guide

ManualsBrandsBradley ManualsEmergency & Safety EquipmentBradley Free Standing All Stainless Steel Drench Shower with Pull Rod Activation

P.O. Box 309, Menomonee Falls, WI USA 53052-0309

PHONE 800.BRADLEY (800.272.3539) FAX 262.251.5817

bradleycorp.com

Installation

215-145SS Rev. K; ECM 12-05-016

Page 1 of 5 5/2/2012

S19-110SS

Freestanding Drench Shower

Table of Contents

Pre-Installation Information .............. 2

Installation Instructions.................. 3

Assembly of Components ............... 4

Parts List ............................ 5

Summary of content (5 pages)

PAGE 1
Installation S19-110SS Freestanding Drench Shower Table of Contents Pre-Installation Information . . . . . . . . . . . . . . Installation Instructions . . . . . . . . . . . . . . . . . Assembly of Components . . . . . . . . . . . . . . . Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . 215-145SS Rev. K; ECM 12-05-016 © 2012 Bradley Page 1 of 5 5/2/2012 P.O. Box 309, Menomonee Falls, WI USA 53052-0309 PHONE 800.BRADLEY (800.272.3539) FAX 262.251.5817 bradleycorp.
PAGE 2
S19-110SS Installation IMPORTANT Read this installation manual completely to ensure proper installation, then file it with the owner or maintenance department. Compliance and conformity to drain requirements and other local codes and ordinances is the responsibilityof the installer. Installation Packing List IS TH SIDE UP • • • • Separate parts from packaging and make sure all parts are accounted for before discarding any packaging material.
PAGE 3
S19-110SS Installation Installation Supplies Required: • (3) 3⁄8" floor anchors and bolts • Pipe sealant • Piping to 1¼" NPT water supply inlet on unit • Adequate supply pipe supports • Min. 4" drain to accommodate 30 gallons per minute discharge for shower waste • OPTIONAL: sign-mounting hardware 26½" (673mm) 3¾" (95mm) Step 1: Secure base to floor 1½" (38mm) 1. Install three suitable anchors (supplied by installer) for 3⁄8" bolts in the floor. 25½" (648mm) 2.
PAGE 4
S19-110SS Installation Assembly of Components 8 5 1¼" NPT Supply Inlet 9 11 12 12.1 14 12.2 12.11 10 NOTE: If tee (upper Item 5) is used as the supply inlet, then relocate coupling (Item 4) to this location. 7 15 16 2 13 6 5 1¼" NPT Supply Inlet 4 17 114-050 P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA TEL: 1-800-BRADLEY FAX: (262-251-5817) http://www.bradleycorp.com 3 R P.O. Box 309, Menomonee Falls, WI 53051 TEST THIS UNIT EACH WEEK DIESES GERÄT 1ST WÖCHENTLICH ZU PRÜFEN.
PAGE 5
S19-110SS Installation Parts List Item Part No. Qty Description Item Part No. Qty Description 1 131-062 1 Base 12.1 S27-276 1 Ball Valve 1" with Jam Nut 2 269-1048 2 Coupling 12.11 161-079 1 Jam Nut only 3 113-1182 1 Pipe, Stainless Steel 1¼" NPT x 32" 12.