Installation manual

Express
®
Crescent
®
Lavatory System CRS-Series
Installation CRS-2/IR, CRS-3/IR
Bradley Corporation • 215-1330 Rev. M; ECN 11-08-011 11-15-2011 7
Installation Instructions continued . . .
Step 8: Electrical and supply connections
NOTE: Refer to Figure 6a below for CRS-2/IR or Figure 6b on page 8 for CRS-3/IR.
WARNING: The Adaptive
®
Infrared control must be connected with a 24 VAC Class II transformer.
Connections to 110 VAC will result in damage to the electronics and can cause
personal injury.
CAUTION: Connection of leads other than shown may cause permanent damage to the sensor.
NOTE: Compliance and conformity to local codes and ordinance is the responsibility of the installer.
NOTE: The solenoid valves have been pre-wired.
1. Snap the senser circuit plug from the bowl into the solenoid circuit plug located on the valve bracket.
2. Snap the transformer circuit plug into the female transformer circuit plug located on the valve bracket.
Figure 6a
Green Supply Tube
(From Sprayhead)
Sensor Circuit Plug
Transformer
Circuit Plug
Red Supply Tube
(From Sprayhead)
Compression Nut
(110-231)
Red Spade Terminal
White Spade Terminal
Green Spade Terminal