Installation manual

Express
®
Crescent
®
Lavatory System CRS-Series
Installation CRS-2/IR, CRS-3/IR
Bradley Corporation • 215-1330 Rev. M; ECN 11-08-011 11-15-2011 5
Installation Instructions continued . . .
Step 3: Install wall anchors
1. Measure and mark the centerline of the lavatory system on the wall.
3. Using cardboard template 186-1311 provided, mark six mounting holes on wall.
3. Drill holes in the wall and install the six
3
/8" wall anchors with a minimum pull-out rating of 1,000 lbs.
(supplied by installer) at the locations shown in Figure 1 on page 3.
NOTE: The six
3
/8" anchors will be used to mount the Crescent
®
bowl to the wall.
4. OPTIONAL TRAP COVER: Install the ¼" wall anchor for the Trap Cover (supplied by installer) as shown
on Figure 1. Use Trap Cover to locate.
5. OPTIONAL SOAP TANK: Install ¼" anchors for soap tank installation (refer to soap system installation
manual #215-1583 for further instructions).
Step 4: Remove cover from bowl assembly
1. Unpack the bowl and cover assembly.
2. Remove the wing nuts on the two threaded rods which retain the cover (see Figure 3).
3. Remove the top cover bracket.
4. Lift the cover off and set aside.
Step 5: Mount the bowl to the wall
WARNING: Do not attempt to install the bowl by yourself. To prevent serious injury, install the bowl
with the assistance of another person and always use appropriate lifting procedures.
1. With someone to assist you, move the bowl assembly to the wall using appropriate lifting procedures,
secure the bowl to the wall.
2. Level the bowl assembly with shims if necessary and then tighten anchors.
Figure 3
Wing Nut
(161-076)
Top Cover Bracket
(140-852)
Top Cover
Threaded Rod
(330-078)