Installation manual

Express
®
Deck Lavatory System EXD-Series
EXD-2N Installation
6 3/2/2012 Bradley Corporation • 215-1542 Rev. F; ECN 11-08-011
*
*
*
*
*
*
Installation Instructions continued . . .
Step 2: Mounting frame to wall
1.UsingaT20Torxkey,removethesix#10-24flatheadTorxscrewsand#10finish
washerssecuringtheaccesspaneltothemainframe,andremovethepanel(Figure2).
2.Positiontheframeagainstthewall,ensuringthatitislevel.
IMPORTANT: Anchoring the frame to a wall that is not flat may cause the frame to
bend, making it difficult to reinstall the access panels.
3.Ensurethatthebackoftheframeisflatagainstthewall.
Figure 3
Figure 2
4. Once you have positioned
the frame such that it is
level (and resting on the
floor, standard height frame
only) and flat against the
wall,usethe3/8”boltsand
1”min.O.D.washersto
mounttheframetothewall
(Figure 3).
5. When mounting the
standard height frame,
mount the scuff base to the
wallatthesametimeusing
thetwoadditional3/8”bolts
andwashersmentionedin
Step1,procedure#3on
page 4 (Figure 3).
Main Frame
Access Panel
#10-24Panel
Fasteners and Washes
(6) Places
Scuff Panel
(Standard Height
Frame Only)
Scuff Panel Fasteners
and Washers
(4) Places
Main Frame
3
⁄8" Wall Anchors
(4) Places
Scuff Base Frame
(Standard Height
Frame Only)
3
⁄8" Wall Anchors
(2) Places
(Standard Height
Frame Only)