Installation manual

Aerada 1000/1100 Series Installation

12 5/21/08 Bradley Corporation • 215-1628 Rev. A; EN 08-201

CARE AND MAINTENANCE INSTRUCTIONS

The following instructions are described in this section:

• Activating Cleaning Mode

• Replacing Battery

• Cleaning or Replacing Inlet Filter

• Adjusting Water Temperature (Internal Mixer)

• Adjusting Hot Water Limiter (External Mixer)

• Cleaning or Replacing Aerator

Activating Cleaning Mode

In order to set the cleaning mode, the faucet needs to be have been set once into

the “Manual Setting” mode. See “Manual Setting” instructions. When cleaning

mode is activated, the faucet will be inoperable for 90 seconds.

1 Fully cover sensor with hand, until water ﬂ ow stops. (This takes approximately

5 seconds.)

2 Remove hand.

Result: Cleaning Mode is now activated.

Replacing Battery

A traditional lavatory faucet is shown as an example. These instructions apply to

all DC models.

Prerequisites

• Battery is low (LED is lit)

• New 6 V Lithium battery (CR-P2) is required

1 Remove shut-off screw

2 Remove mixer handle (for faucets with external mixer only)

3 Remove housing vertically.

4 Remove used battery from battery holder and recycle.

5 Insert new battery.

> LED lights up for 1 second

6 Mount housing vertically.