Specification Sheet

817
Grab Bar
© 2018 Bradley
P.O. Box 309, Menomonee Falls, WI 53052-0309
800 BRADLEY (800 272 3539) [phone]
bradleycorp.com
Orders composed of products indicated as Bradex
®
will be available to ship in three days after receipt of
order at the factory. There is no pricing penalty for
this service from Bradley.
Page 1 of 1 3/27/2018
This information is subject to change without notice.
Bradley_GrabBar_817
1½" O.D. heavy duty stainless steel grab bar with exposed
mounting:
Product Materials
FLANGES: 3
1
⁄8" dia. 11 gauge stainless steel, with exposed surfaces in architectural
satin finish.
TUBING: 1½" O.D. 18 gauge stainless steel, seamless construc tion with exposed
surfaces in architectural satin finish. Bent ends of tubing pass thru the flanges and are
welded into a single structural unit for maximum strength. Intermediate supports are
contour cut and joined by welding to form an integral part of the grab bar. All exposed
welds ground and polished to blend. Mandrel bending process maintains uniform bar
diameter. Return provides 1½" stan dard safety clearance between wall and bar.
Strength
When properly mounted, all Bradley heavy duty grab bar systems meet or exceed the
requirements of ANSI Standard A117.1, the ADA and ABA Accessibility Guidelines
for Buildings and Facilities (ADAAG), and the Uniform Federal Accessibility Standard
(UFAS). All standard (non-bariatric) grab bars are rated to support up to 250
pounds. Please see Bradley's website for more information on all bariatric grab bar
configurations.
Installation
For instructions on installation, warnings and maintenance, please visit www.bradleycorp.com.
Optional Features
Features Suffix

Safety-grip finish -2

High-polish finish -4

Safety grip with high-polished finish -7
Guide Specification
Grab bar shall be fabricated of satin finish stainless steel with exposed mounting flanges
in sizes and configurations as indicated. Install with Bradley Mounting Kits as indicated.
ADA Compliant
Consult local and national accessibility codes for proper installation guidelines.
Conformity and compliance to local and national codes is the responsibility of the
installer.
Bradex
®
Models
Configuration Number Shipping Data
Cu. Ft. Wt. Lbs.
001-36" 0.15 3
001-42" 0.15 4
* 1½" wall clearance required
under most building design codes
* 1½"
(38mm)
Mounting holes
(countersunk)
Flange of 11 gauge
stainless steel
Bar welded
to flange for
maximum
strength
Mandrel
bending process
maintains
uniform bar
diameter
(No. 4) Satin finish
will not scratch
hands or catch dirt
18 gauge
stainless steel
¹⁄₈"
(3mm)
Standard finish
Safety-Grip finish
3¹⁄₈"
(79mm)
exposed