Installation Sheet
www.bradleycorp.com
INTRODUCTION
1. Dismantling for installation
2. Mounting
INSTALLATION
Loosen lock screws in clockwise direction with security wrench provided (P/N: P15-419). (See figure 1).
Remove cover vertically (See Figures 2-4), taking care to avoid:
- Damaging internal components.
- Damaging cover.
Technical Features:
Cover Options:
Cast Iron White Porcelain
Steel White Epoxy
Stainless Steel Satin Finish
Surface Mounted ADA Compliant
Sensor Operated
Universal Voltage: 100-240 Volt at 50/60 Hz
Adjustable Range Detection: 2-8 inches (5-20 cm)
Adjustable Motor Speed: 43 to 70 CFM at 64-70 dB.
Vandal Resistant Operating Sytstem.
NOTE: For dryer to function properly, a minimum of 16 inches (41 cm) should be spaced between
the hand dryer sensor and any obstruction such as shelves, hand washing stations, or any type
of reflective surface (See Figure 11).
MACHINE SHOULD BE INSTALLLED AND SERVICED BY A QUALIFIED TECHNICIAN
181
Be sure power supply is disconnected prior to mounting
The appliance's electrical installation is made via rear channelling (see figure nº 5),
as follows
:
1.- Drill four Ø 5/16 inches (Ø 8 mm) holes using the supplied template.
Clean up the holes once they have been made. Insert the four plugs
until they are flush with the surface (see figure 6).
2.- Pass the 3 electric cables (3 cables 16 AWG/105ºC) from the wall
through the entrance hole (Ø 55/64 inches -2 2 mm - ) as
figure
nº 8 shows.
See annexe for more information about mounting instructions
Figure nº 5
Figure nº 1 Figure nº 2
Figure nº 3 Figure nº 4
ANNEX / ANNEXE
MOUNTING ITEMS PROVIDED.
4 screw.
4 Plug.
1 Mounting template.
1 Instruction manual.
ÉLÉMENTS DE MONTAGE FOURNIS.
4 vis.
4 chevilles.
1 Modèle de montage.
1 Manuel d'instructions.
MOUNTING INSTRUCTIONS.
To mount onto wall, be sure there are no hidden
electrical circuits or pipes in the mounting location.
Place the mounting template (provided) on the wall
to mark location of four mounting screw holes.
Drill four holes (Fig.1) Ø 5/16 inches (Ø 8mm)
diameter and inches 1 ¾ (45 mm.) depth.
Take off the residual dust from the holes.
Insert nylon plugs (provided) into four holes
(Fig.2-3).
Place base plate on wall (Fig.4).
Fix the base plate firmly on the wall (Fig.5-6).
INSTRUCTIONS DE MONTAGE.
En cas de montage sur un mur, s'assurer qu'aucun circuit
électrique et qu'aucun tuyau ne sont dissimulés derrière
l'emplacement choisi pour le montage.
Placer le modèle de montage (fourni) sur la paroi pour
marquer l'emplacement des quatre trous pour les vis.
Percer quatre trous (Figure 1) de 5/16" (8 mm) de diamètre,
et de 1 3/4" (45 mm) de profondeur.
Enlever la poussière des trous.
Insérer les chevilles en nylon (fournies) dans les quatre
trous (Figures 2-3).
Placer la plaque de base sur la paroi (Figure 4).
Fixer solidement la plaque de base sur la paroi
(Figures 5-6).