Installation / Operation Instruction Manual

Step 1: Press “Select” and “Temperature Up” buttons together and hold for 3 seconds until “Max Setpoint” is

shown in the display.

Step 2: Pressing “Select” button will change display to next mode

The following is the sequence of modes available in “Service Mode” by pressing the “Select” button:

Error Code Number (Display/Reset). This is only shown if there is an operating error in the “User Mode”.

NOTICE

Approximately 12 minutes after the last button press, the display will automatically return to the “User Mode”.

Simultaneously pressing the “Select” and “Temperature Up” buttons will switch the display immediately to the “User

Mode”.

SELECT

SET

Status

°F

idle

Operational

Water

Temp



SELECT Lockout RESET

Status

Service Needed

Error Code Shown in

Water Heater Display

SELECT SET

Status

idle

Operational



Max

Setpoint

°F

“Max Setpoint” next

to Temperature

Setpoint value.