Service Manual

Transformer Replacement Procedure

WARNING

120 volt potential exposure. Isolate the

appliance and reconfirm power is

disconnected using a multi-meter.

Step 1. Position main power switch to “OFF”

Step 2. Disconnect (unplug) water heater from 120

volt power source.

Step 3. Un-latch and remove top su

rround cover

from top of water heater.

Step 4. Disconnect primary leads (black & white) and

secondary leads (blue & yellow) from the

transformer.

(leads are different sizes to

prevent interchanging)

Step 5. Remove the 2 screws ( short Phillips screw driver)

holding the trans

former in place and remove

transformer from control panel. (see photo right)

Step 6.Install new transformer and secure in

place with screws from

step 5.

Step 8. Reconnect primary and secondary wires to

transformer (leads are different sizes to prevent

interchanging).

Step 9. Res

tore 120 volt power supply to water

heater and confirm proper operation following

the lighting instructions on the lighting

instruction label or

the lighting instruction

located in the installation and operating

instruction manual.

Step 10. Replace surround cover on top of water heater.

Step 4

Remove wires to

transformer

Step 5

Remove transformer

mounting screws