Service Manual

Control Board Replacement

Step 1. Position main power switch to “OFF”

Step 2. Disconnect (unplug) water heater from 120

volt power source.

Step 3. Un-latch and remove top su

rround cover

from top of water heater.

Step 4. Locate control board.

Step 5. Remove 4 screws that attach display panel

to control panel (save screws).

Step 6.

Carefully disconnect all wire connections from

control board (Identify all wire connections)

Step 7. Depress tabs on the top of control first then til

the control forward.

Step 8. Unhook the tabs on the control out of the slots on

the control panel and remove control.

Step 9. Replace co

ntrol board and all wire connections.

Step 10. Re-attach the display panel from step 5 using the

same screws.

Step 11. Restore 120 volt power s

upply to water

heater and confirm proper operation following

the lighting instructions on the lighting

instruction label or the lighting ins

truction

located in the installation and operating

instruction manual.

Step 12. Replace surround cover on top of water heater.

WARNING

120 volt potential exposure. Isolate the

appliance and reconfirm power is

disconnected using a multi-meter.

Unclip this

side second

Remove

Screws (X4)

Control Board

Display panel

Identify wires for

proper re-connection

Unclip this

side first