Installation / Operation Instruction Manual

Pre-installation continued-

APPLIANCE LOCATION

1. Boiler Location – Locate the indirect-fired water heater as close

to the boiler as practical.

2. Fixture Locations – For fastest delivery of hot water, place the

indirect-fired water heater close to points of use.

ADDITIONAL RECOMMENDED COMPONENTS

1. Shut-off Valves – Allows isolation of water heater from

domestic water system and/or boiler system during service.

2. Unions – Allows water heater movement during service if

adequate clearance cannot be provided.

3. Thermal Expansion Tank – If the water heater is installed in a

closed water supply system, such as one having a back-flow

preventer in the cold water line, provide thermal expansion

control. Contact the water supplier or local plumbing inspector

for additional information.

WARNING

DO NOT plug the inlet and outlet tappings of tankless heater left

installed in the boiler.

MOVE THE WATER HEATER TO A PERMANENT

POSITION BY SLIDING OR WALKING.

NOTICE

Note: Per Section 507.2 Seismic Provisions of the 2021 Uniform

Plumbing Code (UPC). Water heaters shall be anchored or

strapped to resist horizontal displacement due to earthquake

motion. Strapping shall be at points within the upper one-third

and lower one-third of its vertical dimensions. At the lower point,

a distance of not less than 4 inches shall be maintained from

the controls with the strapping.

Please refer to the local authority having jurisdiction to see if

there are any additional local requirements regarding seismic

provisions.