Installation / Operation Instruction Manual

SECTION VI

ELECTRICAL CONNECTIONS

Install electric wiring in accordance with National Electric Code

or the Canadian Electrical Code and local regulations. See the

boiler’s installation manual for wiring diagrams.

This indirect-fired water heater is supplied with an aquastat

temperature control. This aquastat must be properly installed

in the aquastat well location of the water heater. Refer to

Figure 6. Remove the cover and loosen the clamping screws.

Insert the aquastat capillary bulb to the well bottom as shown

and screw the aquastat clamp securely in the well groove. The

aquastat acts as a thermostat for zone control and should be

wired accordingly. Refer to the boiler or zone control

manufacturer’s instructions if any additional wiring is required.

The control is factory set at 120°F (49°C) and care should be

made to not rotate this dial while wiring the control. Once

electrical connections are complete, secure the aquastat cover

back in place.

DANGER

Positively assure all electrical connections are unpowered

before attempting installation or service of electrical components

or connections of the water heater or building. Lock out all

electrical boxes with padlock once power is turned off.

WARNING

When installed, the water heater must be electrically grounded

in accordance with local codes or, in the absence of local codes,

with the National Electrical Code, ANSI/NFPA 70, and /or the

CSA C22.1 Electric Code (latest editions).

Failure to properly wire electrical connections to the water

heater may result in serious physical harm.

Electrical power may be from more than one source. Make sure

all power is off before attempting any electrical work.