Installation / Operation Instruction Manual

25
Operating Instructions continued-
Figure 8 - Aquastat Control
After the indirect-fired water heater completes a heat-up cycle, check
the water temperature at a faucet. Allow enough water to flow to ensure
that the water temperature reflects the tank temperature. Adjust the
water heater’s temperature setting as necessary.
Adjusting to a lower temperature setting will not immediately affect
water temperature. Draw sufficient water or allow the water heater to
remain idle until a heat-up cycle is initiated. After the heater’s heat-up
cycle is complete, check the water temperature at a faucet to determine
if further adjustment is necessary.
Adjusting to a higher temperature may not immediately affect water
temperature. If a heat-up cycle begins, allow the heat-up cycle to
complete before checking the water temperature. If a heat-up cycle
does not begin, draw sufficient water or allow the water heater to
remain idle until a heat-up cycle is initiated. After the heater’s heat-up
cycle is complete, check the water temperature at a faucet to determine
if further adjustment is necessary.