Installation / Operation Instruction Manual

General Information continued-

SECTION IV

PRE-INSTALLATION

UNPACKING

INSPECT SHIPMENT carefully for any signs of damage. If damage is

noted, DO NOT install the product. Contact the shipper or

manufacturer. All equipment is carefully manufactured, inspected, and

packed. Our responsibility ceases upon delivery of the packaged water

heater to the carrier in good condition.

NOTE: Any claims for damage or shortage in shipment must be

filed immediately against the carrier by the consignee.

This water heater MUST be installed indoors out of the wind

and weather.

WARNING

Install a discharge line so that water discharged from the

temperature and pressure relief valve will exit within six (6) inches

above, or any distance below, the structural floor and cannot

contact any live electrical part. The discharge line is to be installed

to allow for complete drainage of both the temperature and

pressure relief valve and the discharge line. The discharge opening

must not be subjected to blockage or freezing. DO NOT thread,

plug, or cap the discharge line. It is recommended that a minimum

clearance of four (4) inches be provided on the side of the water

heater for servicing and maintenance of the combination

temperature and pressure relief valve.

DO NOT place a valve between the combination temperature

and pressure relief valve and the tank.

WARNING

This product contains one or more chemicals known to the

State of California to cause cancer, birth defects, or

reproductive harm.