Service Manual

Page
12
Figure 9 – Display LCD Description
Control Panel Operation:
Power:
• To start the appliance, press the On/Off button.
• To shut down the appliance, press the On/Off button again.
Reset Errors:
• Some error codes can be solved by resetting the appliance. To do this, press and hold the
On/Off button for more than 3 seconds. The appliance will initiate the start-up sequence.
Set Water Temperature:
• By default, the unit is set for 120 °F.
• Press the Up or Down button until you reach the desired temperature.
• Once the user has selected the desired temperature and would like to set this as the default
temperature, press the P button for 3 seconds. The selected temperature will blink. Once this
is completed, the default temperature is saved.
• If the desired temperature setpoint is above the limit of the appliance, the user must change
the Setpoint Limit (continue reading below).
12