Installation / Operation Instruction Manual

Operation instructions

RTG-K-199/160N/X1 – 6 720 817 984 (2022/06)

Fig. 37 Connecting power supply cord

[1] Power cord length: 5.9ft (1.8m).

Note: The power supply that the appliance is plugged into

should be isolated from possible water damage. Observe

proper clearance to avoid damages.

5.2 Position of the fuses in control unit

To check fuses, proceed as follows:

▶ Remove the front cover, see fig. 3, page 12.

▶ Disconnect all the cables from the control unit.

▶ Press the four snaps of the control unit and remove the

cover.

Fig. 38 Control Unit

▶ Press the four snaps inside the control unit and remove the

PCB.

▶ Check the fuse on the printed circuit board for electrical

continuity, see fig. 39, [1].

Fig. 39 Fuse position

[1] Fuse

▶ After checking the fuses, reinstall all parts in reverse order.

6 Operation instructions

Fig. 40

[1] On/Off button

[2] Program Key

[3] LCD display

[4] Up button

[5] Down button

NOTICE:

Instruction to clean display

▶ Wipe down with a damp cloth. Do not use any aggressive or

corrosive cleaning agents to clean the window.