Installation instructions FOR OUTDOOR APPLIANCES Connecting cable 6 720 887 627 (2018/05) US 7736505664
Contents Contents 1 Explanation of symbols and safety instructions . . . 3 1.1 Guideline to symbols . . . . . . . . . . . . . . . . . . . 3 1.2 Safety instructions . . . . . . . . . . . . . . . . . . . . 3 2 Information about the accessory . . . . . . . . . . . . . . . 4 2.1 Cable specifications . . . . . . . . . . . . . . . . . . . 4 2.2 Proper use . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 3 Scope of delivery . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Explanation of symbols and safety instructions 1 Explanation of symbols and safety instructions 1.1 Guideline to symbols Warnings Warnings in this document are identified by a warning triangle printed against a grey background. Keywords at the start of a warning indicate the type and seriousness of the ensuing risk if measures to prevent the risk are not taken. Keywords at the start of a warning indicate the type and seriousness of the ensuing risk if measures to prevent the risk are not taken.
Information about the accessory General information This manual is available in English. ▶ Keep this manual for future use. ▶ Observe the safety instructions of this manual before putting the heating appliance into operation. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. ▶ Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
Installation instructions 4 4.2 Installation instructions Remove the HMI from water heater ▶ Loosen the two Phillips head screws located on the bottom of the front cover. ▶ Remove the front cover by lifting and pulling towards you. The HMI is inside the water heater. 2. 6720887267-01.1V Fig. 2 Outdoor appliance 6720887627-02.1V 4.1 Safety instructions Before removing the front cover: ▶ Disconnect the appliance from the power supply. ▶ Turn off the gas shut-off valve. 1. Fig.
Installation instructions ▶ Disconnect cable from the HMI board. ▶ Choose the wire as center to fix the base. 1. 6720882320-12.1V Fig. 9 Wires inside the wall 6720882320-10.1V Fig. 6 Disconnect cable ▶ Remove the detachable surface, when wires are outside the wall. ▶ Remove two Phillips screws from the HMI support base. 6720882320-11.1V Fig. 10 Wires outside the wall ▶ Install fixing base in a wall. Fig. 7 Removing base ▶ Secure the internal cable with a cable tie. 2.
Installation instructions ▶ Connect the cable to the HMI. ▶ Turn on the gas shut-off valve. 6720882320-16.1V Fig. 15 Connect the appliance 6720882320-13.1V Fig. 12 Connection of the HMI ▶ Assemble the HMI interface to the base. 6720882320-14.1V Fig. 13 Assemble HMI ▶ Connect the cable to the water heater and HMI. 1. Fig. 14 6720887627-03.1V Connect cable After mounting the front cover in the appliance: ▶ Connect the appliance to the power supply.
6720887627
