Installation / Operation Instruction Manual

ManualsBrandsBradford White ManualsPlumbingResidential Power Vent Gas Water Heater with 50 Gallon Capacity and 40000 BTU

Venting continued-

Venting System Condensation

Condensate formation does not occur in all installations of power vented water

heaters but should be protected against on installations where condensation

can form in the venting system.

Formation of condensation in the venting system of Power Vented water

heaters is dependent upon installation conditions including, but not limited to:

• ambient temperature and humidity of installation location,

• ambient temperature and humidity of venting space,

• vent distance and slope,

• and product usage.

NOTICE

For installations in Canada, field supplied vent piping must comply with CAN/CGA

B149.1 (latest edition) and be certified to the Standard For Type BH, Class II, 65°C,

Gas Venting Systems, ULC S636. Components of this listed system shall not be

interchanged with other vent systems or unlisted pipe/fittings. All components and

specified primers and cements of the certified vent system must be from a single

system manufacturer and not intermixed with other system manufacturer’s vent

system parts. The supplied vent connector and vent termination are certified under

ULC S636 and are also certified as part of the water heater. Refer to the following

tables for approved venting materials, primers, and cements. All approved primers

and cements are to be used within their marked time limitations.

Approved Venting Materials

For installations in the US only

• PVC DWV Sch. 40 (ASTM D-2665)

• PVC Sch. 40 (ASTM-D1785)

• CPVC Sch. 40 (ASTM-F441, ASTM-

D2846)

• PVC and CPVC (UL 1738, ULC S636)

• ABS Sch. 40 DWV (ASTM D2661)

• Polypropylene (UL 1738, ULC S636)

For installations in CANADA

• ULC S636 approved PVC for flue gas

venting rated Class II, 65°C

• ULC S636 approved CPVC for flue

gas venting rated Class II, 65°C

• ULC S636 approved Polypropylene

for flue gas venting rated Class II,

65°C

Approved Primers and Cements

For installations in the US only

• PVC and CPVC Primer (ASTM-F656)

• PVC Cement (ASTM D-2564)

• CPVC Cement (ASTM F493)

• ABS Primer and Cement (ASTM D-2235)

For installations in CANADA

• ULC S636 approved Primer and

Cement for flue gas venting rated

Class II, 65°C

NOTICE

Use of cellular core PVC (ASTM F891), cellular core CPVC, or Radel

(polyphenosulfone) in non-metallic venting systems is prohibited and covering

non-metallic venting with thermal insulation is prohibited.