Product Overview

Residential Power Direct Vent
Energy Saver Gas Water Heater
The Power Direct Vent Models Feature:
■ ENERGY STAR
®
Qualified—Some models qualify for the September 1, 2010
minimum ENERGY STAR
®
EF requirement, as well as most utility rebate programs.
■ Bradford White ICON System
™
—Intelligent gas control with spark to pilot ignition
system eliminates the constant burning pilot. This results in savings of pilot gas during
standby periods (120 V.A.C.).
-- Enhanced Performance—Proprietary algorithms provide enhanced First Hour
Delivery ratings and tighter temperature differentials.
-- Advanced Temperature Control System—Microprocessor constantly monitors and
controls burner operation to maintain consistent and accurate water temperature
levels.
-- Intelligent Diagnostics—An exclusive green LED light prompts the installer during
start-up and provides ten different diagnostic codes to assist in troubleshooting.
-- Separate Immersed Thermowell—High-strength advanced polymer composite
thermowell provides isolation between electric temperature sensor and surrounding
water. No need to drain the tank when removing gas valve.
■ Closed Combustion Venting System—Power Direct Vent models are ideal for
installations which lack sufficient are for combustion, such as new construction homes
or additions which are tightly insulated. These models use a twin pipe system where
combustion air is drawn from outside the building in one pipe, and combustion
products are expelled to the outside in another pipe.
■ Cast Aluminum Air Intake Boot—A cast molded air intake boot design provides
exceptional durability during installation and operation.
■ Horizontal and Vertical Venting—PVC, ABS, or CPVC. The equivalent feet of intake
venting cannot be greater than the equivalent feet of exhaust venting.
■ Optional Concentric Vent Kit Termination—Termination fitting provides for only one
exit opening through a wall or roof. (Subtract 10ft. for intake pipe and 10ft. for exhaust
pipe when calculating total vent length.)
■ Flammable Vapor Sensor—Electronic sensor prevents burner operation if flammable
vapors are detected. The sensor will also prevent burner operation if there is an
ongoing flammable vapor burn inside the combustion chamber (excluding
RG2PDV75H6N).
■ Factory-Installed Hydrojet
®
Total Performance System—Cold water inlet sediment
reducing device helps prevent sediment build-up in tank. Increases first hour delivery
of hot water while minimizing temperature build-up in tank.
■ Vitraglas
®
Lining—Bradford White tanks are lined with an exclusively engineered
enamel formula that provides superior tank protection from the highly corrosive effects
of hot water. This formula (Vitraglas
®
) is fused to the steel surface by firing at a
temperature of over 1600°F (871°C).
■ 2" Non-CFC Foam Insulation—Surrounds the tank surface, saving energy by
retarding loss of heat.
■ Water Connections— 3⁄4" NPT factory-installed true dielectric fittings extend water
heater life and make installation easier.
■ Side Connections— 3/4" NPT tappings allow easy connections for space heating
applications (Potable water only) (RG2PDV50H6N & RG2PDV75H6N only).
■ Factory Installed Heat Traps—Design incorporates a flexible disk that reduces heat
loss in piping and eliminates the potential for noise generation.
■ Protective Magnesium Anode Rod—Provides added protection against corrosion for
long trouble-free service.
■ T&P Relief Valve—Installed.
■ Low Restriction Brass Drain Valve—Durable tamper-proof design.
6 or 10-Year Limited Tank Warranties / 6 or 10-Year Limited Warranty on Component Parts.
For more information on warranty, please visit www.bradfordwhite.com
For products installed in USA, Canada and Puerto Rico. Some states do not allow limitations on warranties. See complete
copy of the warranty included with the heater.
Photo is of
RG2PDV40S6N
MANUFACTURED UNDER ONE OR MORE OF THE FOLLOWING U.S. PATENTS: 5,682,666; 7,634,976; 5,660,165; 5,954,492; 6,056,542; 6,935,280; 5,372,185; 5,485,879; 5,574,822; 7,971,560; 7,992,526;
6,684,821; 6,442,178; 7,334,419; 7,866,168; 7,270,087; 7,007,748; 5,596,952; 6,142,216; 7,699,026; 5,341,770; 7,337,517; 7,665,211; 7,665,210; 7,063,132; 7,063,133; 7,559,293; 7,900,589; 5,943,984;
8,082,888; 5,988,117; 7,621,238; 7,650,859; 5,761,379; 7,409,925; 5,277,171; 8,146,772; 7,458,341; 2,262,174. OTHER U.S. AND FOREIGN PATENT APPLICATIONS PENDING. CURRENT CANADIAN PATENTS:
2,314,845; 2,504,824; 2,108,186; 2,143,031; 2,409,271; 2,548,958; 2,112,515; 2,476,685; 2,239,007; 2,092,105; 2,107,012. Defender Safety System
®
, Vitraglas
®
and Hydrojet
®
are registered trademarks of
Bradford White
®
Corporation.
1117-A-0215
FEATURING:
NAECA
Compliant
2015