User Guide

Temperature sensor

Insertion stick

SERVICE PROCEDURE RG-VI

Gas Control Testing, Disassembly &

Replacement (Honeywell)

GAS CONTROL DISASSEMBLY/REASSEMBLY

Step 12. Remove temperature sensor from insertion stick by pulling apart as illustrated below.

Pull in this direction

Step 13. To reassemble gas control, follow the previous steps in reverse order. Once gas control is

reassembled, burner assembly is reinstalled, and the gas supply line is reconnected, resume

water supply to water heater. Be sure tank is full of water before relighting.

Step 14. To resume operation, follow the instructions located on the lighting instruction label or the lighting

instructions located in the installation and operation manual.