Install Instructions

Venting continued-

Through The Roof Venting (Vertical Venting Concentric Vent

Terminal):

Cut the necessary holes through the roof and ceiling and install the vent

connector as shown in Figure 7. Make sure that the installation meets the local

codes and/or the National Fuel Gas Code ANSI Z223.1 (Latest Edition) or

CAN/CGA B149 installation code (latest edition).

Figure 7

NOTE: For installations requiring both horizontal and vertical runs, the following

rule must be followed: Total length of straight pipe (both horizontally and

vertically) must not exceed the equivalent length listed in these

instructions. For the concentric vent terminal, the maximum vent length is

reduced by 10 ft. (3.1 m).