Installation / Operation Instruction Manual

Maintenance continued-

4. If the combination temperature and pressure relief valve on the

appliance discharges periodically, this may be due to thermal expansion

in a closed water supply system. Contact the water supplier or local

plumbing inspector on how to correct this situation. Do not plug the

combination temperature and pressure relief valve outlet for any reason.

5. Monthly, drain off a gallon of water from the water heater to remove silt

and sediment.

6. A combination sacrificial anode rod/hot water outlet nipple has been

installed to extend tank life. The anode rod should be inspected

periodically (every 2 years) and replaced when necessary to prolong

tank life. Water conditions in your area will influence the time interval for

inspection and replacement of the anode rod. Contact the plumbing

professional who installed the water heater, or the manufacturer listed on

the rating plate for anode replacement information. The use of a water

softener may increase the speed of anode consumption. More frequent

inspection of the anode is needed when using softened (or phosphate

treated) water.

WARNING

When lifting lever of temperature-pressure relief valve, hot water

will be released under pressure. Be certain that any released water

does not result in bodily injury or property damage.

WARNING! THIS WATER MAY BE HOT.

CAUTION

FOR YOUR SAFETY, DO NOT ATTEMPT TO REPAIR

THERMOSTAT(S), HEATING ELEMENTS, OR ELECTRICAL WIRING.

REFER SUCH REPAIRS TO A QUALIFIED SERVICE TECHNICIAN.