Service Manual

Troubleshooting
Accessing Service Mode on Control Display
F
or models with Honeywell Integrated Control
Step 2: Press “Set” button to enter setting mode. “Max Setpoint” will flash to indicate setting mode.
Step 3: Press the “UP” or “DOWN” buttons to change the maximum setpoint value. This will limit the maximum setpoint
the user can select. Note: The maximum setpoint is approximately 180°F.
Step 4: Press “Set” button to confirm new “Max Setpoint” value and stop setting mode.
"Max Setpoint" stops flashing
SELECT SET
Statu
s
°F
idle
O
p
erational
Max
Set
p
oin
t
%
SELECT SE
T
Status
°F
idle
Operational
Max
S
etpoin
t
%
"Max Setpoint" continues to flash
while making adjustments
24
S
ELECT SET
Status
°F
idle
O
perational
Max
Setpoint
%
"Max Setpoint" Flashes
24