Installation / Operation Instruction Manual

General Information continued-

WARNING

Install a discharge line so that water discharged from the

temperature and pressure relief valve will exit within six (6) inches

above, or any distance below, the structural floor and cannot

contact any live electrical part. The discharge line is to be installed

to allow for complete drainage of both the temperature and

pressure relief valve and the discharge line. The discharge opening

must not be subjected to blockage or freezing. DO NOT thread,

plug, or cap the discharge line. It is recommended that a minimum

clearance of four (4) inches be provided on the side of the water

heater for servicing and maintenance of the combination

temperature and pressure relief valve.

DO NOT place a valve between the combination temperature and

pressure relief valve and the tank!

SACRIFICIAL ANODES – Two sacrificial anode rods have been

installed in the tank head to extend tank life. The removal of any anodes,

except for inspection and/or replacement, will nullify the warranty. The

anode rods should be inspected annually to determine the amount of

sacrificial decay and replaced when necessary to prolong tank life. Water

conditions in your area will influence the time interval for inspection and

replacement of the anode rod. The use of a water softener may increase

the speed of anode consumption. More frequent inspection of the anode

is needed when using softened (or phosphate treated) water. Contact

the plumbing professional who installed the water heater or the

manufacturer, listed on the rating plate, for anode replacement

information.

SECTION IV

PRE-INSTALLATION

UNPACKING

INSPECT SHIPMENT carefully for any signs of damage. If damage is

noted, do not install the product. Contact the shipper or manufacturer. All

equipment is carefully manufactured, inspected, and packed. Our

responsibility ceases upon delivery of the packaged water heater to the

carrier in good condition.

NOTE: Any claims for damage or shortage in shipment must be filed

immediately against the carrier by the consignee.

This water heater MUST be installed indoors out of the wind and

weather.