Installation / Operation Instruction Manual

General Information continued-

WARNING

Install a discharge line so that water discharged from the

temperature and pressure relief valve will exit within six (6) inches

above, or any distance below, the structural floor and cannot

contact any live electrical part. The discharge line is to be installed

to allow for complete drainage of both the temperature and

pressure relief valve and the discharge line. The discharge opening

must not be subjected to blockage or freezing. DO NOT thread,

plug, or cap the discharge line. It is recommended that a minimum

clearance of four (4) inches be provided on the side of the water

heater for servicing and maintenance of the combination

temperature and pressure relief valve.

DO NOT place a valve between the combination temperature and

pressure relief valve and the tank!

SACRIFICIAL ANODES – Two sacrificial anode rods have been

installed in the tank head to extend tank life. The removal of any

anodes, except for inspection and/or replacement, will nullify the

warranty. The anode rods should be inspected annually to

determine the amount of sacrificial decay and replaced when

necessary to prolong tank life. Water conditions in your area will

influence the time interval for inspection and replacement of the

anode rod. The use of a water softener may increase the speed of

anode consumption. More frequent inspection of the anode is

needed when using softened (or phosphate treated) water.

Contact the plumbing professional who installed the water heater

or the manufacturer, listed on the rating plate, for anode

replacement information.

SECTION IV

PRE-INSTALLATION

UNPACKING

INSPECT SHIPMENT carefully for any signs of damage. If damage

is noted, do not install the product. Contact the shipper or

manufacturer. All equipment is carefully manufactured, inspected,

and packed. Our responsibility ceases upon delivery of the

packaged water heater to the carrier in good condition.

NOTE: Any claims for damage or shortage in shipment must be

filed immediately against the carrier by the consignee.

This water heater MUST be installed indoors out of the wind and

weather.