Installation / Operation Instruction Manual

Operating Instructions continued-

Figure 8 – Thermostat

After the indirect-fired water heater completes a heat-up cycle, check the

water temperature at a faucet. Allow enough water to flow to ensure that

the water temperature reflects the tank temperature. Adjust the water

heater’s temperature setting as necessary.

Adjusting to a lower temperature setting will not immediately affect water

temperature. Draw sufficient water or allow the water

heater to remain idle until a heat-up cycle is initiated. After the heater’s heat-

up cycle is complete, check the water temperature at a faucet to determine

if further adjustment is necessary.

Adjusting to a higher temperature may not immediately affect water

temperature. If a heat-up cycle begins, allow the heat-up cycle to complete

before checking the water temperature. If a heat-up cycle does not begin,

draw sufficient water or allow the water heater to remain idle until a heat-up

cycle is initiated. After the heater’s heat-up cycle is complete, check the

water temperature at a faucet to determine if further adjustment is

necessary.

SECTION VIII

MAINTENANCE

This indirect-fired water heater is intended to provide a service life of

many years. Components that require service, however, may be subject

to failure. Failure to use the correct procedures or parts in these

circumstances may make the water heater unsafe.

The owner should arrange to have the following inspections and simple

maintenance procedure performed by qualified service personnel at the

frequencies suggested.