Solid Vent Kit Install Instructions

10
Figure 7
9. Extend the five (5) inch (12.7 cm) diameter telescopic tube to its
maximum length. Place the large end of the five (5) inch (12.7 cm)
diameter telescopic tube over the collar on the outer wall mount plate.
Drill three (3) 1/8 inch (3.0 mm) diameter holes, 120
o
apart, through the
five (5) inch (12.7 cm) diameter telescopic tube into the collar on the
outer wall mount plate. Fasten with three
(3) #8 sheet metal screws
(supplied). Using the supplied special RTV silicone sealant, apply a
sufficient amount to seal the joint (See Figure 8).
Figure 8