Solid Vent Kit Install Instructions

13
12. Mark the mounting screw hole locations for the backing plate. Rotate
the backing plate in order to gain access to the markings. With a 3/16
(4. 5 mm) inch diameter drill bit (not supplied), drill holes for the
supplied wall anchors. Install the wall anchors and secure the backing
plate to the wall with four (4) #10 x 1 inch screws (supplied) (See Figure
12). Note: Certain construction of walls may require the use of a
different type of anchoring means than supplied.
Figure 12
IMPORTANT
When the installation is complete, visually inspect the air intake
system to insure that all joints are completely sealed.