Owner manual

Page 77
BRUTE ELITE
12 Internal fault:
Safety relay drive cap short
H Internal fault
1. Reset module
2. If fault repeats, replace module.
13 Internal fault:
PII (Pre-Ignition Interlock)
shorted to ILK (Interlock)
H or L Internal fault
1. Reset module
2. If fault repeats, replace module.
15 Internal fault:
Safety relay test failed due to
feedback ON
L Internal fault
1. Reset module
2. If fault repeats, replace module.
16 Internal fault:
Safety relay test failed due to
safety relay OFF
L Internal fault
1. Reset module
2. If fault repeats, replace module.
17 Internal fault:
Safety relay test failed due to
safety relay not OFF
L Internal fault
1. Reset module
2. If fault repeats, replace module.
18 Internal fault:
Safety relay test failed due to
feedback not ON
L Internal fault
1. Reset module
2. If fault repeats, replace module.
19 Internal fault:
Safety RAM write
L Internal fault
1. Reset module
2. If fault repeats, replace module.
20 Internal fault:
Internal fault: Flame ripple and
overow
H Internal fault
1. Reset module
2. If fault repeats, replace module.
21 Internal fault:
Flame number of sample
mismatch
H Internal fault
1. Reset module
2. If fault repeats, replace module.
22 Internal fault:
Flame bias out of range
H Internal fault
1. Reset module
2. If fault repeats, replace module.
23 Internal fault:
Bias changed since heating cycle
starts
H Internal fault
1. Reset module
2. If fault repeats, replace module.
24 Internal fault:
Spark voltage stuck low or high
H Internal fault
1. Reset module
2. If fault repeats, replace module.
25 Internal fault:
Spark voltage changed too much
during ame sensing time
H Internal fault
1. Reset module
2. If fault repeats, replace module.
26 Internal fault:
Static ame ripple
H Internal fault
1. Reset module
2. If fault repeats, replace module.
Code Description L or H Procedure