Owner manual

Page 29
BRUTE ELITE
Figure24-DHWPiping,TwoHeaters,OneVerticalTank
Figure25-DHWPiping,TwoHeaters,TwoVerticalTanks
NOTES:
1. Optional CWMU & Recirc. line location.
2. Locate BNTV DHW sensor or remote aquastat
well in lower 1/3 of tank.
3. Back ow preventer may be required - check
local codes.
4. Thermal expansion tank may be required -
check local codes.
5. Factory mounted pumps are sized for a max
pipe length of 30’ total, 6-90° elbows, full pipe size.
6. Caution:Pumpsizingmustbebasedon
waterhardnessatjobsite.
WARNING: This drawing shows
suggested piping conguration and
valving. Check with local codes and
ordinances for additional requirements.
NOTES:
1. Optional CWMU & Recirc.
line location.
2. Locate BNTV DHW sensor
or remote aquastat well
in lower 1/3 of tank.
3. Back ow preventer may be
required - check local codes.
4. Thermal expansion tank may be
required - check local codes.
5. Factory mounted pumps are sized
for a max pipe length of 30’ total,
6-90° elbows, full pipe size.
6. Caution:Pumpsizingmust
bebasedonwater
hardnessatjobsite.
WARNING: This drawing shows
suggested piping conguration and
valving. Check with local codes and
ordinances for additional requirements.