Owner manual

Page 28
BRADFORD WHITE CORP.
Figure23-DHWPiping,OneHeater,TwoVerticalTanks
NOTES:
1. Optional CWMU & Recirc. line location.
2. Locate BNTV DHW sensor or remote aquastat well
in lower 1/3 of tank.
3. Back ow preventer may be required - check local codes.
4. Thermal expansion tank may be required - check local codes.
5. Factory mounted pumps are sized for a max pipe length of
30’ total, 6-90° elbows, full pipe size.
6. Caution:Pumpsizingmustbebasedonwater
 hardnessatjobsite.
WARNING: This drawing shows
suggested piping conguration and
valving. Check with local codes and
ordinances for additional requirements.